Caliber Stamford ConcreteCaliber Stamford Concrete(475) 333-3026
Caliber Stamford Concrete
(475) 333-3026Get an estimate

Concrete Contractor in Rye Brook, NY - driveways and patios that drain right

Caliber Stamford Concrete is a concrete contractor based in Stamford, CT, and we cross the state line to pour driveways, patios, walks and steps in Rye Brook, NY, built on a dug-out, packed base so they sit flat.

Get an estimate(475) 333-3026
Aerial view of a paved pool deck with a circular compass-star design beside a rock-lined garden stream.

Rye Brook, a Westchester village next door to Greenwich

Rye Brook is a village in Westchester, just over the state line from Greenwich, and an easy run from where we're based in Stamford. The calls we get from places like it are mostly residential, the driveways, patios, front walks and steps around a house, plus the odd lot or foundation for a property manager. Next door in Port Chester, we do the same work.

On a house lot, new concrete has to fit what's already there, like the garage floor, the door sills, the lawn and the beds. So the job usually comes down to where the water goes and what the old slab was sitting on, and we find that out before we price anything.

Concrete services we bring to Rye Brook homes and properties

We bring our full list of work to Rye Brook, from driveways and patios to footings, foundations and saw-cutting. Every job starts the same way. I come out, look at the old slab, see where the water runs and check what's under it, then write an estimate that shows what's in it. My crew does the work, and I'm there for the steps that decide how it holds up, like the base going in and the pour.

  • Concrete driveway building

    A driveway that's cracked, sunk or holding puddles usually sits on a base that settled. We dig the old one out, pack new base and pour it sloped away from the house.

    Explore service

  • Concrete patio construction

    A back patio is where people sit, so a slab that tips toward the house or pools water gets old fast. We set the slope away from the house before anything gets poured.

    Explore service

  • Stamped concrete services

    Stamped concrete gives a patio or walk the look of stone or brick. We press the pattern in while the concrete is still soft, so pour-day timing decides how it turns out.

    Explore service

  • Concrete sidewalk building

    Front walks heave when roots or settling push one panel above the next. We pull the bad sections, fix the base and cut control joints, grooves that tell a crack where to go.

    Explore service

  • Garage floor concrete

    A garage floor that's pitted, cracked or tipped the wrong way lets water sit where you park. We break it out, rebuild the base and pour a new slab that drains toward the door.

    Explore service

  • Decorative concrete

    Decorative concrete covers color, exposed stone and textured finishes for the front walk or patio people actually see. We pick the finish with you on site, because some look better than they wear.

    Explore service

  • Concrete retaining walls

    A yard that keeps slumping downhill on a sloped lot usually needs a retaining wall. We build the footing and the drainage behind it first, because trapped water is what pushes walls over.

    Explore service

  • Concrete floor installation

    Basements, workshops and additions need a floor flat enough to build on. We pack the subgrade, the dirt the slab sits on, and pour it level before anything goes on top.

    Explore service

  • Concrete pool decks

    A pool deck stays wet and gets walked on barefoot, so slick or sharp finishes don't belong there. We slope it away from the pool and give it a texture that grips.

    Explore service

  • Concrete steps construction

    Front steps that have sunk, chipped or pulled away from the house are a trip waiting to happen. We set new steps on a proper footing so they stay put against the house.

    Explore service

  • Slab foundation building

    An addition, garage or outbuilding on a slab needs it level and solid before framing starts. We dig out and pack the base, set the rebar, steel bars that hold the slab together, and pour.

    Explore service

  • Foundation installation

    New construction and additions start with a foundation that has to be square, level and on solid ground. We lay it out, form it and pour it so the framers start from a true line.

    Explore service

  • Concrete parking lot building

    Property managers call when a lot has potholes, standing water or slabs that rock when cars cross them. We plan the slope to the drains first, then pour it thick enough for the traffic.

    Explore service

  • Concrete footings

    Decks, porches, walls and additions all sit on footings, and a shallow one is why a post starts to lean. We dig to firm ground and pour them before anything goes up.

    Explore service

  • Foundation raising

    A slab or foundation that has dropped at one corner shows it in sticking doors, cracks and a tilt you can feel. We find out why it sank first, then lift and support it.

    Explore service

  • Concrete cutting

    Running a new drain line, widening an opening or removing one bad section means cutting concrete cleanly. We saw-cut along a straight line so the patch or opening looks planned.

    Explore service

Photos of the kind of concrete work we do

These photos show the kinds of driveways, patios, steps and walls we build, not specific Rye Brook jobs. Look past the fresh finish to the edges and the slope, because that's where good concrete shows.

  • Concrete driveway with light gray slabs and red brick borders, beside a parked golf cart and landscaped yard.

  • Textured concrete pool deck surrounding a swimming pool, with patio steps and a covered seating area.

  • Curving concrete sidewalk beside a stone house, with a gravel bed, potted plant, and black metal bench.

What working in Rye Brook means for your concrete job

Rye Brook has its own permit rules, so a job here has a few steps before any concrete shows up. Here's how those steps work, what we do about them and what decides your price.

The village Building Department decides on permits

In Rye Brook, permits come from the village Building Department, which enforces both the state building code and the village's own. For a driveway or patio, plan on a wait before we dig, because older village instructions put exterior permits behind Architectural Review Board approval, a design review that comes first. Ask the department what that step looks like for your job now.

That older instruction sheet also asked for the contractor's valid Westchester County Home Improvement License once design approval came through, so it's fair to ask any contractor about it before you sign. Before we start, we check with the building office and tell you what it wants for your job. If a permit is needed, we handle the application with you, and if the office hasn't answered yet, we say so.

  • On the older sheet, the full permit fee was paid before issue.
  • We're licensed and fully insured, and we'll show you proof.
  • We plan the start date around the permit, not ahead of it.

What moves the price and the schedule

The price comes down to size, whether an old slab has to come out, how much base we dig out and pack, and the finish. A plain broom finish, the light texture that keeps it from getting slick, costs less than stamped or colored work. The base is the first thing people want to cut, and it's the one I won't, because nobody sees it until the slab settles.

The schedule turns on the permit and any review ahead of it, then on the pour itself. We pour early in the day when we can, because a slab that cooks in midday heat ends up with a weak, dusty top. After that comes curing, the wait while the concrete gains strength, and you stay off it until it's ready. For your own figure, the written estimate I send shows what's in it.

  • Breaking out and hauling away an old slab adds labor.
  • Fixing drainage, so water runs away from the house, adds prep.
  • Rebar adds cost and helps keep a crack from opening wide.

Get a free on-site concrete estimate in Rye Brook

Send the form or call (475) 333-3026, and we'll reply within one business day to set a time. I come out to Rye Brook myself, walk the job and measure, then send you a written estimate that shows what's in it. It's free, and there's no pressure to book.

(475) 333-3026

What we check on the driveways, patios and steps here

Most concrete problems we're called about start under the slab or at its edges, not on top. These are the things I look for on every visit, here and in the cities around Rye Brook.

  • Slabs that slope the wrong way

    On a lot of driveways and patios we look at, the slab pitches back toward the garage or the house, so rain runs to the one place you don't want it. We fix that in the base and the forms, before any concrete shows up.

  • Old slabs poured on raked dirt

    Plenty of cracked driveways and patios were poured on dirt that was raked flat, not dug out and packed. The dirt settled and the slab went with it. When we replace one, we dig down to firm ground and pack a new base so it has something to sit on.

  • Thin patches over old cracks

    We often find a thin layer poured over an old cracked slab to hide it. The cracks usually come back through within a few seasons, because the problem was underneath the whole time. We'd rather break it out and fix the base than add another layer.

  • Cracks where nobody planned them

    Random cracks running across a slab usually mean the control joints were cut late or skipped. Concrete shrinks as it cures, and it cracks somewhere. We cut ours on time, so when a crack does show up, it usually lands in the groove where nobody notices it.

  • Tight access and finished yards

    Many jobs mean getting a truck or wheelbarrows past lawns, beds and fences without wrecking them. Access changes how we plan the pour and what it costs, so I look at it on the estimate visit and tell you what we'll protect and how.

Why hire a Stamford concrete crew for Rye Brook work

We've been pouring concrete in Stamford and across the line in Westchester since 2017. Here's what you get when you call us, and the one place I won't save you money.

The base gets the extra hour, not the finish

Every slab job has a trade-off between what's under it and what's on top. The finish is what you see on day one, so it's tempting to spend there and cut corners on the base. I go the other way. A nice looking slab on a bad base is just an expensive crack waiting to happen, and you'd be paying to break it out.

So we dig the old base out instead of raking it level, pack the new one and check where the water runs before the forms go in, so the slab falls away from the house. I ran a landscaping business for years before concrete, which is why I look at the yard around the slab too. I'd rather spend an extra hour on prep than explain a crack later.

  • I write every estimate myself

    I come out to look at every job myself and write the estimate. You talk to the person who's responsible for the work, and the written estimate shows what's in it, so you're not left guessing what you paid for.

  • Licensed, insured and happy to prove it

    We're licensed and fully insured. Ask for the paperwork before you sign anything, from us or anyone else, because if something goes wrong on your property, you want to know whose insurance answers for it.

  • On site for the base and pour

    My crew does the work, and I'm on site for the steps that matter most, the base going in, the forms and slope being set and the pour itself. Those are the parts you can't fix later without breaking concrete.

  • Straight answers about cracks

    Concrete cracks. It's practically a hobby. We cut joints so it cracks where we choose and build the base so it doesn't sink, and I'll tell you up front where a crack might show. Satisfaction guaranteed. Call (475) 333-3026 to set up a visit.

Rye Brook concrete questions we hear before the estimate

In Rye Brook, the first questions are usually about permits and paperwork, then about the concrete. Here are the straight answers, with the village office to check where the final word is theirs.

Do I need a permit to pour a concrete driveway or patio in Rye Brook, NY?

Plan on it, because Rye Brook requires a permit for almost all interior and exterior work. The Building Department asks owners to check with it before starting a project, so that's the first call on any slab job. We make that call before we start and tell you what the office wants for yours.

How do I apply for a building permit online in Rye Brook?

You apply through the village's online permit portal, which takes building permit applications from residents, contractors and business owners. The same portal handles plans, inspection scheduling and tracking where your permit stands, so you can see its progress there while we work through the application with you.

How do I know if my new driveway needs a stormwater permit in Rye Brook?

On older village forms, a project that disturbed 400 square feet or more of land, or added 400 square feet or more of hard surface that water can't soak into, also needed a Stormwater Management Control Permit. A new driveway or a big patio can pass that size easily. Ask the Building Department whether the rule still applies to your job, and we'll factor the answer into the plan.

How much does a new concrete driveway cost in Rye Brook?

Your price is set by the size, the tear-out of the old slab, how much base has to be dug out and packed, and the finish, and I give you the figure in a written estimate after I walk the job. In Rye Brook, the permit and any village review mostly add time rather than concrete, and a bigger slab can bring in the stormwater question above. Call (475) 333-3026 or send the form to set up the visit.

Service areas

Rye Brook is one of 12 areas with a page here, along with Stamford, Greenwich, Rye and Port Chester. If yours isn't listed, call (475) 333-3026 or send the form, since we work in the cities around them too.

Ask about your location
(475) 333-3026Get an estimate